This assay has high sensitivity and excellent specificity for detection of Melatonin (MT). No significant cross-reactivity or interference between Melatonin (MT) and analogues was observed.
精密度:
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Melatonin (MT) were tested 20 times on one plate, respectively. Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Melatonin (MT) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100; Intra-Assay: CV<10%; Inter-Assay: CV<12%.
稳定性:
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
检测原理:
This assay employs the competitive inhibition enzyme immunoassay technique. A monoclonal antibody specific to Melatonin (MT) has been pre-coated onto a microplate. A competitive inhibition reaction is launched between biotin labeled Melatonin (MT) and unlabeled Melatonin (MT) (Standards or samples) with the pre-coated antibody specific to Melatonin (MT). After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of Melatonin (MT) in the sample. After addition of the substrate solution, the intensity of color developed is reverse proportional to the concentration of Melatonin (MT) in the sample.
实验流程:
1. Prepare all reagents, samples and standards;
2. Add 50ul standard or sample to each well.
And then add 50ul prepared Detection Reagent A immediately.
Shake and mix. Incubate 1 hour at 37℃;
3. Aspirate and wash 3 times;
4. Add 100ul prepared Detection Reagent B. Incubate 30 minutes at 37℃;
5. Aspirate and wash 5 times;
6. Add 90ul Substrate Solution. Incubate 10-20 minutes at 37℃;
7. Add 50ul Stop Solution. Read at 450 nm immediately.